Articles

PurposeTo initialize hard disk or perform the failure prediction test.Procedure1. Enter Diagnostics, GP 1.2. Touch dC355 Hard Disk Diagnostics.3. Touch Failure Prediction Test or Initialize Hard Disk.4. Follow the UI messages, then touch Start.5. The result is displayed. Touch Close.6. Touch Close to return to the Hard Disk Diagnostics screen.7. Touch Back to return to the Diagnostics screen.**This procedure is from Xerox Service Manual. All brand names and trademarks are their respective owner's property.**You may be also interested in below toner and drum chip (CRUM) for Xerox VersaLink C7020, C7025, C7030, C7000.Toner Chip (For North America and West Europe Region):•...

PurposeTo show the status of input components e.g. sensors, and to run or energize output components e.g. motors, solenoids.DescriptionOutput and input component codes are entered into the Component Control Table on the UI, and then checked individually or in permitted groups. The codes in the tables are grouped in function chain order. Refer to GP 2 Fault Codes and History Files.NOTE: To check the operation of the fuser temperature, tray size sensing, development housing ATC sensors and MOB sensor, refer to dC140 Analog Monitor.Go to the appropriate procedure:• Input Components• Output ComponentsInput ComponentsWhen the appropriate code is entered, the status...

PurposeTo test the LED and audio functions of the user interface.Procedure1. Enter Diagnostics, GP 1.2. Touch dC305 UI Panel Diagnostics.3. Touch LED Test or Audio Test.4. Exit diagnostics, GP 1.LED Test1. Touch the 1 or more LEDs to be diagnosed:• Interactive• Error• NFC• Power• Data2. Touch the display pattern to be diagnosed. The selected LEDs are switched on.3. Touch All Off.4. Touch the back button (top left) to return to the Diagnostics screen.Audio Test1. Touch Volume. Adjust the volume as necessary.2. Touch the pattern to be diagnosed. The audio sounds with the specified volume and pattern:• Pattern 1• Pattern 2•...

PurposeTo reset the values of all applicable NVM parameters to default.Procedure1. Enter Diagnostics, GP 1.2. Touch dC301 Initialize NVM.3. Select the area to be initialized. Refer to Table 1. Table 1 NVM areas  Area Comments IOT 1 Drive PWB NVM. After initializing the IOT 1 NVM, ensure the tray module type is correctly set, refer to the 077-211 Tray Module Mismatch RAP. IOT 2 Do not use. Finisher Integrated finisher or LX office finisher NVM. IFM Do not use. IISS - IIT/IPS Scanner NVM. IISS - Extension Do not use. Input Device DADF NVM. Sys - System ESS PWB NVM....

PurposeTo provide tools to start (actuate) and stop (de-actuate) monitoring of specific analog components. The nominal range of the analog value and, when monitoring is active, the current value is displayed. The values are updated at least every second to allow the component state to be monitored.Procedure1. Enter Diagnostics, GP 1.2. Touch dC140 Analog Component Monitoring.3. Touch Chain-Link.4. Enter the relevant Chain-Link number, refer to Table 1.5. Touch OK.6. Touch Start. The screen will display the information that follows:• Chain-Link number of the component.• Input or output code clarification.• The enabled or disabled state.• The output level.7. To temporarily change...