How to Enter dC301 NVM Initialization for Xerox VersaLink C7020 C7025 C7030 C7000 Printer?

Posted by Xwk Tech on


To reset the values of all applicable NVM parameters to default.


1. Enter Diagnostics, GP 1.
2. Touch dC301 Initialize NVM.
3. Select the area to be initialized. Refer to Table 1.

Table 1 NVM areas
 Area Comments
IOT 1 Drive PWB NVM. After initializing the IOT 1 NVM, ensure the tray module type is correctly set, refer to the 077-211 Tray Module Mismatch RAP.
IOT 2 Do not use.
Finisher Integrated finisher or LX office finisher NVM.
IFM Do not use.
IISS - Extension Do not use.
Input Device DADF NVM.
Sys - System ESS PWB NVM.
Sys - User SD card customer settings. The installation wizard will have to be run after initializing the SD card NVM.
Fault Counter Fault history.
HCS 1 Do not use.
HCS 2 Do not use.
PFIM Do not use.

4. Touch Start.
5. Follow the UI messages to initialize the NVM.
6. Touch Close to return to the Diagnostics screen.
7. Enter dC131. Ensure NVM value 790-900 is set to 1. If the NVM value was changed, switch off, then switch on the machine, GP 10. Verify that the Embedded Web Server is working.
8. Exit diagnostics, GP 1.

**This procedure is from Xerox Service Manual. All brand names and trademarks are their respective owner's property.**

You may be also interested in below toner and drum chip (CRUM) for Xerox VersaLink C7020, C7025, C7030, C7000.

Toner Chip (For North America and West Europe Region):

106R03741 106R03744 106R03743 106R03742
106R03757 106R03760 106R03759 106R03758
106R03737 106R03740 106R03739 106R03738

Toner Chip (For South America and East Europe Region):

106R03749 106R03752 106R03751 106R03750
106R03745 106R03748 106R03747 106R03746
106R03765 106R03768 106R03767 106R03766

Toner Chip (For Metered Machine):

106R03733 106R03736 106R03735 106R03734

Drum Chip:

113R00780 113R00782

Share this post

← Older Post Newer Post →

Leave a comment