How to Fix 092-651 Error Code for Xerox VersaLink C7020 C7025 C7030 C7000 Printer?

Posted by Xwk Tech on

092-651 RC Sample Block Fail-B RAP

BSD-ON: BSD 9.9 ADC and Environment Sensing, BSD 9.4 Development (1 of 2).

092-651 An abnormal read value of the IBT sensor was detected.

Initial Actions

Power off then power on the machine, GP 10.

Procedure

WARNING: Ensure that the electricity to the machine is switched off while performing tasks that do not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause death or injury. Moving parts can cause injury.

Refer to the procedure that follows as necessary:

GP 7 How to Check a Sensor.

1. Check the wiring between the drive PWB and the applicable MOB ADC sensor for open circuits, short circuits or damage. The connection is good. If YES, go to 3. If NO, go to 2.

2. Reconnect or repair the wiring between the drive PWB and the MOB ADC sensor.

3. Install new parts as necessary:

• MOB ADC sensor assembly, PL 90.40 Item 6. Enter dC675, perform the registration control setup cycle
• Drive PWB, PL 1.10 Item 4.
• IBT belt unit, PL 90.45 Item 1.

NOTE: Following installation of the new IBT belt unit, enter dC135 code 954-820 to reset the HFSI value for the BTR Unit

• LVPS, PL 1.10 Item 3.
• ESS PWB, PL 3.10 Item 6.

**This RAP is from Xerox Service Manual. All brand names and trademarks are their respective owner's property.**

You may be also interested in below toner and drum chip (CRUM) for Xerox VersaLink C7020, C7025, C7030, C7000.

Toner Chip (For North America and West Europe Region):

106R03741 106R03744 106R03743 106R03742
106R03757 106R03760 106R03759 106R03758
106R03737 106R03740 106R03739 106R03738

Toner Chip (For South America and East Europe Region):

106R03749 106R03752 106R03751 106R03750
106R03745 106R03748 106R03747 106R03746
106R03765 106R03768 106R03767 106R03766

Toner Chip (For Metered Machine):

106R03733 106R03736 106R03735 106R03734

Drum Chip:

113R00780 113R00782

Share this post



← Older Post Newer Post →


Leave a comment