How to Fix 089-601 089-603 Error Code for Xerox VersaLink C7020 C7025 C7030 C7000 Printer?

Posted by Xwk Tech on

089-601, 089-603 RC Sample Block Fail-A1 RAP

BSD-ON: BSD 9.9 ADC and Environment Sensing.

089-601 During the A1 (fine adjustment pattern) and C patch detection, the patch at the MOB ADC Sensor In did not satisfy the defined number of valid sample blocks.
089-603 During the A1 (fine adjustment pattern) and C patch detection, the patch at the MOB ADC Sensor Out did not satisfy the defined number of valid sample blocks.

Initial Actions

Enter dC125, if multiple chain 89 faults are indicated, refer to Chain 089 Entry RAP to determine the highest priority fault.

Procedure

WARNING: Ensure that the electricity to the machine is switched off while performing tasks that do not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause death or injury. Moving parts can cause injury.

Refer to the procedure that follows as necessary:

GP 7 How to Check a Sensor.

Perform the steps that follow:

1. Check the applicable MOB ADC sensor for contamination, open circuits, short circuits or damage:
2. If the fault persists, install a new MOB ADC sensor assembly, PL 90.40 Item 6.
3. Enter dC675, perform the registration control setup cycle.

**This RAP is from Xerox Service Manual. All brand names and trademarks are their respective owner's property.**

You may be also interested in below toner and drum chip (CRUM) for Xerox VersaLink C7020, C7025, C7030, C7000.

Toner Chip (For North America and West Europe Region):

106R03741 106R03744 106R03743 106R03742
106R03757 106R03760 106R03759 106R03758
106R03737 106R03740 106R03739 106R03738

Toner Chip (For South America and East Europe Region):

106R03749 106R03752 106R03751 106R03750
106R03745 106R03748 106R03747 106R03746
106R03765 106R03768 106R03767 106R03766

Toner Chip (For Metered Machine):

106R03733 106R03736 106R03735 106R03734

Drum Chip:

113R00780 113R00782

Share this post



← Older Post Newer Post →


Leave a comment