Articles

058-310 to 058-321 Fuser Checkout RAPBSD-ON: BSD 10.2 Fusing Heat Control (1 of 2)BSD-ON: BSD 10.3 Fusing Heat Control (2 of 2)058-310 At warm up, the heat roll NC sensor temperature has exceeded the check temperature.058-311 At warm up, the heat roll thermistor temperature has exceeded the check temperature.058-318 After inspection start, the side temperature rises from the measurement start temperature to the target temperature sooner than the specified time.058-319 The heater assessment time has arrived, the center temperature or side temperature is the setting value or less.058-320 The side temperature does not rise to the measurement start temperature within...

057-317 Drive PWB F17 Blown RAPBSD-ON: BSD 1.10 Power Interlock Switching (3 of 3)057-317 Drive PWB fuse 17 open circuit was detected.ProcedureWARNING: Ensure that the electricity to the machine is switched off while performing tasks that do not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause death or injury. Moving parts can cause injury.Perform the steps that follow:1. Check the components that follow for overcurrent and overvoltage. Repair the wiring or install a new exit gate solenoid, PL 10.22 Item 9 as necessary.2. After the faulty circuit has been repaired, install a new drive PWB,...

057-316 Drive PWB F16 Blown RAPBSD-ON: BSD 1.10 Power Interlock Switching (3 of 3)057-316 Drive PWB fuse 16 open circuit was detected.ProcedureWARNING: Ensure that the electricity to the machine is switched off while performing tasks that do not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause death or injury. Moving parts can cause injury.Perform the steps that follow:1. Check the components that follow for overcurrent and overvoltage. Repair the wiring or install new components as necessary:• Takeaway clutch, PL 40.10 Item 5.• Bypass tray feed clutch, PL 70.40 Item 4.• Registration clutch, PL 80.55 Item...

057-311, 313, 314, 315 Drive PWB Fail RAP057-311 Abnormality in the WDT circuit that monitors the SPI communication status in which the drive PWB is mounted.057-313 Drive PWB fuse 13 open circuit was detected.057-314 Drive PWB fuse 14 open circuit was detected.057-315 Drive PWB fuse 15 open circuit was detected.ProcedureWARNING: Ensure that the electricity to the machine is switched off while performing tasks that do not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause death or injury. Moving parts can cause injury.1. Switch off, then switch on the machine, GP 10.2. If the fault persists,...

057-310, 057-312 Drive PWB Communication Fail RAP057-310 SPI communication data abnormality between the drive PWB and the ESS PWB.057-312 SPI communication data abnormality between the drive PWB and the ESS PWB.ProcedurePerform the 045-311, 045-396 Controller Communication Fail RAP.**This RAP is from Xerox Service Manual. All brand names and trademarks are their respective owner's property.**You may be also interested in below toner and drum chip (CRUM) for Xerox VersaLink C7020, C7025, C7030, C7000.Toner Chip (For North America and West Europe Region):• 106R03741 106R03744 106R03743 106R03742• 106R03757 106R03760 106R03759 106R03758• 106R03737 106R03740 106R03739 106R03738Toner Chip (For South America and East Europe Region):•...