Articles

061-354 to 357, 061-362 to 365, 061-366 to 369, 061-370 to 373, 061-390 to 393 LPH Communications Fault RAP061-354 ASIC register error in IBY initial DL check. It may be an error in the yellow LPH (ASIC or memory). It may also be an ASIC malfunction due to poor power supply or a communication error due to poor connection with the ESS.061-355 ASIC register error in IBY initial DL check. It may be an error in the magenta LPH (ASIC or memory). It may also be an ASIC malfunction due to poor power supply or a communication error due to...

060-341 to 060-356 LPH Fault RAPBSD-ON: BSD 6.4 LED Control (Y, M), BSD 6.5 LED Control (C, K)060-341 Large pixel count error between the video output and yellow LPH. Image abnormality may occur.060-342 Large pixel count error between the video output and magenta LPH. Image abnormality may occur.060-343 Large pixel count error between the video output and cyan LPH. Image abnormality may occur.060-344 Large pixel count error between the video output and black LPH. Image abnormality may occur.060-345 Communication error between ESS and yellow LPH. Possibly caused by an external noise.060-346 Communication error between ESS and magenta LPH. Possibly caused...

059-383 Warm Up Time Fail RAPBSD-ON: BSD 10.2 Fusing Heat Control (1 of 2)BSD-ON: BSD 10.3 Fusing Heat Control (2 of 2)059-383 When transitioning from the wait state, the specified temperature is not reached within the specified time.NOTE: This fault may occur when the temperature in the installation environment is low (10 degrees C or lower).ProcedureWARNING: Ensure that the electricity to the machine is switched off while performing tasks that do not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause death or injury. Moving parts can cause injury.Perform the steps that follow:1. Switch off, then...

059-372 Heat Roll NC Sensor Differential Fail RAPBSD-ON: BSD 10.3 Fusing Heat Control (2 of 2)059-372 Abnormal temperature monitor AD value of the heat roll NC sensor was detected 10 consecutive times.ProcedureWARNING: Ensure that the electricity to the machine is switched off while performing tasks that do not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause death or injury. Moving parts can cause injury.Perform the steps that follow:1. Switch off, then switch on the machine, GP 10.2. Ensure that the fuser is installed correctly.3. Check the drawer connector between the fuser ( DJ612) and the...

059-326 Heat Roll STS Fail RAPBSD-ON: BSD 10.3 Fusing Heat Control (2 of 2)059-326 The system detected an open circuit of the heat roll thermistor.Initial ActionsWARNING: Ensure that the electricity to the machine is switched off while performing tasks that do not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause death or injury. Moving parts can cause injury.• Ensure that the fuser is installed correctly.• Check the drawer connector between the fuser ( DJ612) and the main unit ( DP612) for damage.• Ensure P/J416 on the drive PWB is connected correctly.Procedure1. Remove the fuser. Measure...