Articles

062-345 IIT EEPROM Fail RAPBSD-ON: BSD 6.3 Document Illumination and Image Input062-345 Write failure to IEEPROM, or communication failure with EEPROM.ProcedureWARNING: Ensure that the electricity to the machine is switched off while performing tasks that do not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause death or injury. Moving parts can cause injury.1. Switch off, then switch on the machine, GP 10.2. If the fault persists, install a new CCD Assembly, PL 60.10 Item 4.**This RAP is from Xerox Service Manual. All brand names and trademarks are their respective owner's property.**You may be also interested...

062-311 IIT Software Logic Fail RAP062-311 Error detected in IISS software.ProcedureWARNING: Ensure that the electricity to the machine is switched off while performing tasks that do not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause death or injury. Moving parts can cause injury.1. Switch off, then switch on the machine, GP 10.2. Reload the software, GP 4.3. If the fault persists, install a new ESS PWB, PL 3.10 Item 6.**This RAP is from Xerox Service Manual. All brand names and trademarks are their respective owner's property.**You may be also interested in below toner and drum...

062-300 Platen Interlock Open RAPBSD-ON: BSD 6.1 Platen Document Sensing062-300 Any of the faults that follow was detected:• DADF Job was stopped by opening the platen cover.• DADF was opened when the document was set in DADF.• DADF was opened while feeding.ProcedureWARNING: Ensure that the electricity to the machine is switched off while performing tasks that do not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause death or injury. Moving parts can cause injury.Refer to the procedure that follows as necessary:• GP 7 How to Check a Sensor.Perform the steps that follow:1. Ensure that the...

062-277 DADF Communication Fail RAPBSD-ON: BSD 3.5 PWB Communications (ESS PWB to DADF)062-277 Communications cannot be established between the ESS PWB and the DADF PWB.ProcedureWARNING: Ensure that the electricity to the machine is switched off while performing tasks that do not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause death or injury. Moving parts can cause injury.1. Switch off, then switch on the machine, GP 10.2. Check the connections and wiring between the ESS PWB (P/J750) and the DADF PWB (P/J751) for an open circuit, short circuit or poor contact.3. If the fault persists, install...

061-358 to 361 LPH Configuration RAPBSD-ON: BSD 6.4 LED Control (Y, M), BSD 6.5 LED Control (C, K)061-358 The model number of the installed yellow LPH does not match. It may also be a memory error in the LPH.061-359 The model number of the installed magenta LPH does not match. It may also be a memory error in the LPH.061-360 The model number of the installed cyan LPH does not match. It may also be a memory error in the LPH.061-361 The model number of the installed black LPH does not match. It may also be a memory error in...