Articles

Parts List on PL 60.10PurposeTo clean the optics components of the scanner ensuring optimum image quality.NOTE: This adjustment must only be performed if directed to from an Image Quality RAP, or if the optics cavity was opened to install a new component and contamination can be seen on the optics components.ProcedureWARNING: Ensure that the electricity to the machine is switched off while performing tasks that do not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause death or injury. Moving parts can cause injury.1. Remove the document glass, REP 60.1.2. Inspect the cleanliness of the optics...

Parts List on PL 60.10PurposeTo correctly set the CCD lens optical axis after installation of a new CCD lens.Check1. Enter dC945 IIT Calibration.2. Perform the Optical Axis Correction procedure.3. On the result screen, if OK is displayed, no further action is necessary. If NG is displayed, perform the Adjustment. Refer to Table 1. Table 1 Result Optical Axis Correction Optical Axis Correction Result NG Front Nut Correction Angle -: Left rotation +90 Rear Nut Correction Angle +: Right rotation -260 Adjustment1. The result screen will show the information depicted in Table 1:• Front nut refers to the nut at the...

PurposeTo view and, if required, synchronize the serial and product numbers between the drive PWB and ESS PWB when a new drive PWB or ESS PWB has been installed.The serial and product numbers are held at the following locations:• EPROM on the drive PWB (IOT).• EPROM on the ESS PWB (SYS1).• ESS PWB (SYS2).NOTE: This function must only be used when a failure has occurred. When the values at the three locations (IOT, SYS1, SYS2) are the same, there is no need to continue with the procedure.Procedure1. Enter Diagnostics, GP 1.2. Touch dC132 Device ID and Billing Data.3. To change...

PurposeTo adjust the transfer voltage to minimise the transfer capability difference caused by different paper type.Procedure1. Enter Diagnostics, GP 1.2. Touch dC1215 Transfer Voltage Adjustment.3. Follow the on screen instructions.4. Touch Close.5. Touch Close to return to the Diagnostics screen.6. Exit diagnostics, GP 1.**This procedure is from Xerox Service Manual. All brand names and trademarks are their respective owner's property.**You may be also interested in below toner and drum chip (CRUM) for Xerox VersaLink C7020, C7025, C7030, C7000.Toner Chip (For North America and West Europe Region):• 106R03741 106R03744 106R03743 106R03742• 106R03757 106R03760 106R03759 106R03758• 106R03737 106R03740 106R03739 106R03738Toner Chip (For...

PurposeAdjusts toner density. Make this adjustment if the difference between the current TC target number and the TC value number is large (30 or higher).Procedure1. Enter Diagnostics, GP 1.2. Touch dC991 Toner Density Adjustment.3. Observe numbers for TC Target and TC Value for each color. Only make adjustments if difference is greater than 30. To exit at this point, touch Close to return to the Diagnostics screen.4. To proceed with adjustment, touch Number of Sheets.5. For one color only, touch - or + to choose a number of sheets to be printed.NOTE: Negative numbers are permitted. For example entering -6...