Articles

PurposeThe procedure prints out the process control test pattern in two different modes. The comparison between the two prints can help isolate process control related image quality problems. Ensure that paper is loaded in tray 1 before starting this procedure as test patterns are printed.The Procon On/Off Print consists of the following:• Procon On Print: This is a print mode that uses the current Procon Data with the Procon (Process Control) soft enabled and the TRC Adjustment turned on.• Procon Off Print: This is a print mode that uses IOT features with the Procon routine fully turned off.ProcedureProcon On Print1....

PurposeThis procedure allows a manual density adjustment. It sets an offset amount of the ADC lookup table created by the ADC patch to finely adjust the gradation.Procedure1. Enter Diagnostics, GP 1.2. Touch dC924 TRC Manual Adjustment.3. Touch on the color to be adjusted.4. Touch on the - or + for Low, Medium or High to decrease or increase any of these values between -128 and +127.5. Touch Close.6. Touch Close to return to the Diagnostics screen.7. Exit diagnostics, GP 1.**This procedure is from Xerox Service Manual. All brand names and trademarks are their respective owner's property.**You may be also interested...

PurposeThis procedure enables fine adjustment of the center value of the low density/medium density/high density output balance for each color for copy images.Procedure1. Enter Diagnostics, GP 1.2. Touch dC919 Color Balance Set.3. Touch on the color to be adjusted:4. Touch on the - or + for Highlight, Midtone and Shadow to decrease or increase any of the set values between -4 and +4.5. Touch Close.6. Touch Close to return to the Diagnostics screen.7. Exit diagnostics, GP 1.**This procedure is from Xerox Service Manual. All brand names and trademarks are their respective owner's property.**You may be also interested in below toner...

PurposeThis is a setup procedure to be used after removal of key marking module components such as:• LPH.• 2nd BTR.• IBT belt.• IBT cleaning unit.• Belt module.• Developer.Function 1: This is a registration control full cycle that can be performed after NVM initialization. Performing this function corrects the color registration into the predefined range. The corrected shift amount for each color is saved in the NVM and it is displayed at normal completion.Function 2: On entering a setup cycle, the IOT does not start. The registration control shift correction amount is displayed automatically on the UI screen and is used...

PurposeThis is a self-diagnostic cycle for checking that the registration detection system is operating normally. Color shift is detected using a cyan patch. Any misregistration detected in the MOB sensor is displayed on the screen.This detection result is compared with the target value to determine the OK or NG status (OK=Good/Pass, NG=Not Good/Fail). Correction is not performed.Procedure1. Enter Diagnostics, GP 1.2. Touch dC673 Registration Control Sensor Check Cycle.3. Touch Start, the Registration Control Sensor Check Cycle Processing message displays.4. Wait for the process to complete, then touch Close.5. OK or NG is displayed in the Result column for each row.6....