Articles

PurposeTo print marking data.Procedure1. Enter Diagnostics, GP 1.2. Touch dC981 Marking Data Print.3. Touch Start, the Marking Data document is printed.4. Touch Close.5. Touch Close to return to the Diagnostics screen.6. Exit diagnostics, GP 1.**This procedure is from Xerox Service Manual. All brand names and trademarks are their respective owner's property.**You may be also interested in below toner and drum chip (CRUM) for Xerox VersaLink C7020, C7025, C7030, C7000.Toner Chip (For North America and West Europe Region):• 106R03741 106R03744 106R03743 106R03742• 106R03757 106R03760 106R03759 106R03758• 106R03737 106R03740 106R03739 106R03738Toner Chip (For South America and East Europe Region):• 106R03749 106R03752 106R03751...

PurposeTo set the correct altitude for the location of the machine.Procedure1. Enter Diagnostics, GP 1.2. Touch dC980 Altitude Adjustment.3. Touch the relevant altitude for the machine location.4. Touch OK.**This procedure is from Xerox Service Manual. All brand names and trademarks are their respective owner's property.**You may be also interested in below toner and drum chip (CRUM) for Xerox VersaLink C7020, C7025, C7030, C7000.Toner Chip (For North America and West Europe Region):• 106R03741 106R03744 106R03743 106R03742• 106R03757 106R03760 106R03759 106R03758• 106R03737 106R03740 106R03739 106R03738Toner Chip (For South America and East Europe Region):• 106R03749 106R03752 106R03751 106R03750• 106R03745 106R03748 106R03747 106R03746• 106R03765...

PurposeCAUTION: This procedure should only be performed after installation of a new ATC sensor or drum cartridge. Or when there is reason to believe that the calibration values in NVM are incorrect.To acquire the sensitivity correction values (correction coefficient and correction offset) for adjusting the ATC sensor output from the bar code numbers which display the sensitivity attribute in every ATC sensor. The bar code numbers are set in NVM (bar code number) manually from this adjustment screen.Procedure1. Enter Diagnostics, GP 1.2. Touch dC950 ATC Sensor Setup.3. Touch Bar Code No.4. Touch on the - or + for Yellow, Magenta,...

PurposeThis procedure sets the ATC target value by having the ATC sensor measure the toner density of the developer housing assy. This procedure can also work as the check function of the ATC sensors, that measures the toner density of the developing powder and displays readings for ATC measure value ATC target value for all four colors. Below these readings, only fail states are displayed.For each color, there is a setting switch option that can be set to either on or off. If performed in the on state, this procedure changes the value of the ATC target. Perform in the...

PurposeTo perform white reference adjustment, CCD calibration, and optical axis deviation correction for the scanner.Prerequisite• Color test pattern 82E13120.PreparationCAUTION: Only use one of the specified Xerox papers listed in Table 1. The use of non-specified Xerox papers may cause the IIT to be calibrated incorrectly.1. Perform ADJ 60.5 Optics Cleaning Procedure.2. Enter dC131, then read NVM location 715-106.3. Refer to Table 1, then depending on the available paper position 10 sheets on the document glass, then set the NVM 715-106 value to 5, 6, 7 or 8.NOTE: In order to adjust the white reference the NVM 715-106 value needs to...