Articles

010-337 Heat Roll Paper Winding RAPBSD-ON: BSD 10.2 Fusing Heat Control (1 of 2)010-337 From the value of the fuser thermistor and NC sensor, paper was wrapped around the heat roll.ProcedureWARNING: Ensure that the electricity to the machine is switched off while performing tasks that do not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause death or injury. Moving parts can cause injury.Perform the steps that follow:1. Remove any jammed paper from the fuser. Ensure the customer is using paper withinspecification, GP 15.2. If no jammed paper was found, install a new fuser, PL 10.05...

010-334, 010-335 Heat Roll NC Sensor Fail RAPBSD-ON: BSD 10.2 Fusing Heat Control (1 of 2)010-334 Heat roll NC sensor temperature - heat roll thermistor temperature was detected at 90 (NVM) degrees or higher 10 consecutive times or more. Heat roll thermistor temperature – heat roll NC sensor temperature was detected at 70 (NVM) degrees or higher 10 consecutive times or more.010-335 Fuser NC sensor compensation output AD value was detected below 130 degrees for 10 consecutive times or more. Fuser NC sensor detection output AD value was detected below 150 degrees for 10 consecutive times or more.ProcedureWARNING: Ensure that...

010-332, 010-379 Heat Roll NC Sensor Fail RAPBSD-ON: BSD 10.2 Fusing Heat Control (1 of 2)010-332 Fuser NC Sensor compensation AD value or detection AD value was 1020 or more 10 consecutive times.010-379 The time taken to recover from a high temperature not ready state has exceeded the specified time.ProcedureWARNING: Ensure that the electricity to the machine is switched off while performing tasks that do not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause death or injury. Moving parts can cause injury.Perform the steps that follow:1. Switch off, then switch on the machine, GP 10.2....

010-331, 010-333 Over Temperature Fail RAPBSD-ON: BSD 10.2 Fusing Heat Control (1 of 2)010-331 Fuser thermistor detected temperature monitor AD value that is the specified value or more 10 consecutive times.010-333 Fuser NC sensor detected a temperature that is the specified value or more 10 consecutive times.Initial ActionsWARNING: Ensure that the electricity to the machine is switched off while performing tasks that do not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause death or injury. Moving parts can cause injury.• Remove the fuser. Check whether foreign substances or paper is wound around the heat roll.•...

010-329 Fuser Fuse Cut Fail RAPBSD-ON: BSD 10.2 Fusing Heat Control (1 of 2)010-329 After installation of a new fuser, the fuse (F1) for detection is not open within the correct time.ProcedureWARNING: Ensure that the electricity to the machine is switched off while performing tasks that do not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause death or injury. Moving parts can cause injury.Perform the steps that follow:1. Switch off, then switch on the machine, GP 10.2. Ensure that the fuser is installed correctly.3. Check the drawer connector between the fuser and the main unit...