Articles

016-211, 016-212 SW Option Fail Memory Low RAP016-211 Insufficient system memory was detected.016-212 Insufficient Page Memory was detected.ProcedurePerform the steps that follow:1. Switch off, then switch on the machine, GP 10.2. Refer the customer to the User Guide to check memory usage.**This RAP is from Xerox Service Manual. All brand names and trademarks are their respective owner's property.**You may be also interested in below toner and drum chip (CRUM) for Xerox VersaLink C7020, C7025, C7030, C7000.Toner Chip (For North America and West Europe Region):• 106R03741 106R03744 106R03743 106R03742• 106R03757 106R03760 106R03759 106R03758• 106R03737 106R03740 106R03739 106R03738Toner Chip (For South America...

016-210, 506, 777, 780, 798 HDD Error RAPBSD-ON: BSD 3.9 ESS016-210 One of the SW option functions cannot be executed due to a HDD error or HDD not installed.016-506 The log image storage area on the disk is full, a job cannot be continued.016-777 An error other than disk full was detected when opening/reading/writing file for compression conversion/image processing operation.016-780 An error other than HDD full was detected when opening/writing file for operation.016-798 A HDD unavailable error was returned when the decomposer called the S-image library.ProcedureWARNING: Ensure that the electricity to the machine is switched off while performing tasks that...

013-220 Folder Detect Fail RAPBSD-ON: BSD 13.8 Office Finisher LX Folding013-220 Control logic cannot detect the folder assembly.ProcedureWARNING: Ensure that the electricity to the machine is switched off while performing tasks that do not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause death or injury. Moving parts can cause injury.1. Enter dC330 code 013-160 to detect the folder. The displayed state is Low. If YES, go to 5. If NO, go to 2.2. Measure the voltage at P/J8990 pin 4. Less than +1VDC is measured. If YES, go to 4. If NO, go to 3.3....

13-212, 013-213 Booklet Staple Move Position Sensor Fail RAPBSD-ON: BSD 13.16 Office Finisher LX Booklet Staple Positioning013-212 Booklet staple move position sensor does not actuate within designated time period.013-213 Booklet staple move position sensor does not deactuate within designated time period.Initial ActionsWARNING: Ensure that the electricity to the machine is switched off while performing tasks that do not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause death or injury. Moving parts can cause injury.• Ensure the staple head is free from obstructions.• Check dC122 Fault History for 013-306 or 013-307 faults. If either fault is...

013-307 Booklet Left Cover Open RAPBSD-ON: BSD 13.4 Office Finisher LX Booklet Interlock Switching013-307 Control logic senses that the booklet left cover is open.Initial ActionsWARNING: Ensure that the electricity to the machine is switched off while performing tasks that do not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause death or injury. Moving parts can cause injury.Ensure the left cover, PL 13.50 Item 8 is closed.Procedure1. Measure the voltage between P/J8993 pin 5 on the booklet PWB and ground. +24VDC is measured. If YES, go to 3. If NO, go to 2.2. Check the circuit...