PL 80.10 Tray 1 Feeder Assembly for Xerox VersaLink C7020 C7025 C7030 C7000 Printer

Posted by Xwk Tech on


PL 80.10 Tray 1 Feeder Assembly (1 of 2)

PL 80.10 Tray 1 Feeder Assembly for Xerox C7020 C7025 C7030 C7000

Item Part Description
1 - Tray 1 feeder assembly (REF: PL 80.05 Item 1)
2 - Upper frame (P/O PL 80.10 Item 1)
3 - Drive bracket assembly (P/O PL 80.10 Item 1)
4 127K52790 Tray 1 feed/lift motor (MOT71-001)
5 - Chute (P/O PL 80.10 Item 1)
6 930W00123 Tray 1 level sensor (Q71-102)/Tray 1 no paper sensor (Q71-101)
7 - Not used
8 120E22481 Sensor actuator
9 - Harness rear holder (P/O PL 80.10 Item 1)
10 - Gear 31T (P/O PL 80.10 Item 1)
11 - Spacer (P/O PL 80.10 Item 1)
12 - Bearing shaft (P/O PL 80.10 Item 1)
13 - Drive shaft assembly (P/O PL 80.10 Item 1)
14 - Gear 13 (P/O PL 80.10 Item 1)
15 005K83081 One way clutch assembly (P/O PL 80.10 Item 1)
16 - One way gear assembly (P/O PL 80.10 Item 1)
17 - Helical gear 25T (P/O PL 80.10 Item 1)
18 - Helical gear 29/19T (P/O PL 80.10 Item 1)
19 - Sensor harness assembly (P/O PL 80.10 Item 1)
20 - Spring (P/O PL 80.10 Item 1)
21 - Roll assembly (P/O PL 80.10 Item 1)
22 930W00211 Tray 1 pre feed sensor (Q71-105)
23 - Pre feed sensor harness (P/O PL 80.10 Item 1)
24 - Plate earth nudger (P/O PL 80.10 Item 1)
Note: Item 1 contains item 2-24, PL 80.11 Item 1-23.

**This PL 80.10 is from Xerox Service Manual. All brand names and trademarks are their respective owner's property.**

You may be also interested in below toner and drum chip (CRUM) for Xerox VersaLink C7020, C7025, C7030, C7000.

Toner Chip (For North America and West Europe Region):

106R03741 106R03744 106R03743 106R03742
106R03757 106R03760 106R03759 106R03758
106R03737 106R03740 106R03739 106R03738

Toner Chip (For South America and East Europe Region):

106R03749 106R03752 106R03751 106R03750
106R03745 106R03748 106R03747 106R03746
106R03765 106R03768 106R03767 106R03766

Toner Chip (For Metered Machine):

106R03733 106R03736 106R03735 106R03734

Drum Chip:

113R00780 113R00782


Share this post



← Older Post Newer Post →


Leave a comment