Articles

016-711 Email Transmission Size Limit RAP016-711 The size of data to send exceeds the system data value (before connection to the server).ProcedureAdvise the customer to:1. Reduce the resolution level, which is a transmission parameter, then resend the job.2. Reduce the magnification ratio, which is a transmission parameter, then resend the job3. Use System Settings to raise the data size upper limit (recommended default is 2MB).**This RAP is from Xerox Service Manual. All brand names and trademarks are their respective owner's property.**You may be also interested in below toner and drum chip (CRUM) for Xerox VersaLink C7020, C7025, C7030, C7000.Toner Chip...

016-710 Delayed Print Fail RAP016-710 Process conditions for delay print were not met.ProcedureWARNING: Ensure that the electricity to the machine is switched off while performing tasks that do not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause death or injury. Moving parts can cause injury.Perform the steps that follow:1. Advise the customer to:a. If secure print, proof print or knowledge storage print is specified, disable them.b. Reduce the delay print jobs waiting to 100 jobs or less.2. Ensure that all connectors on the ESS PWB, PL 3.10 Item 6 are securely connected. Ensure all surface...

016-709 ART EX Command Error RAP016-709 An ART EX command error occurred during PLW processing.ProcedureWARNING: Ensure that the electricity to the machine is switched off while performing tasks that do not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause death or injury. Moving parts can cause injury.Perform the steps that follow:1. Advise the customer to:a. Switch off parallel bi-directional communication in the printer driver.b. Set a longer time for Auto Output Time.c. Change the PC BIOS settings.d. Use a shorter, genuine, parallel cable.2. Ensure that all connectors on the ESS PWB, PL 3.10 Item 6...

016-708 Annotation/Watermark HDD Full RAP016-708 When an annotation or watermark image was to be stored in the HDD, full status was detected and the job was aborted.ProcedureWARNING: Ensure that the electricity to the machine is switched off while performing tasks that do not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause death or injury. Moving parts can cause injury.Perform the steps that follow:1. Advise the customer to:a. Cancel annotation or watermark, then repeat the operation.b. Reduce the number of document pages. In Mixed Size mode, only a single size is available.c. For printing Stored Document,...

016-707 Sample Print Fail RAP016-707 When receiving Email, fax or internet fax, an invalid (not setup) mailbox number is selected.ProcedureWARNING: Ensure that the electricity to the machine is switched off while performing tasks that do not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause death or injury. Moving parts can cause injury.Perform the steps that follow:1. Advise the customer to:a. Remove the conditions that disable sample print.b. If the fault occurred at installation, check whether the operations for Sample Print are correct.2. Ensure that all connectors on the ESS PWB, PL 3.10 Item 6 are...