Articles

016-721 to 016-724 Settings Error RAP016-721 Paper types cannot be determined because all the settings for custom paper priority are set to disabled.016-722 Staple position that is not supported by this machine or a paper size that is not supported by the Finisher was specified.016-723 Punch position that is not supported by this machine or the paper size that is not supported by the Finisher was specified.016-724 Job canceled due to invalid combination of staple and punch positions.ProcedurePerform the steps that follow:1. Advise the customer to correct the settings, then execute the command again.2. If the fault persists, reload the...

016-720 PCL Command Error RAP016-720 A PCL command error occurred during PCL processing.ProcedurePerform the steps that follow:1. Advise the customer to cancel the job then execute the command again.2. If the fault persists, reload the software, GP 4.**This RAP is from Xerox Service Manual. All brand names and trademarks are their respective owner's property.**You may be also interested in below toner and drum chip (CRUM) for Xerox VersaLink C7020, C7025, C7030, C7000.Toner Chip (For North America and West Europe Region):• 106R03741 106R03744 106R03743 106R03742• 106R03757 106R03760 106R03759 106R03758• 106R03737 106R03740 106R03739 106R03738Toner Chip (For South America and East Europe Region):•...

016-719 Out of PCL Memory RAP016-719 An insufficient memory was detected while using the PCL.ProcedurePerform the steps that follow:1. Advise the customer to increase the PCL memory size. Increasing the memory for the whole system will increase the memory to be allocated to the Decomposer in some measure.2. If the fault persists, reload the software, GP 4.**This RAP is from Xerox Service Manual. All brand names and trademarks are their respective owner's property.**You may be also interested in below toner and drum chip (CRUM) for Xerox VersaLink C7020, C7025, C7030, C7000.Toner Chip (For North America and West Europe Region):• 106R03741...

016-718 Out of PCL6 Memory RAP016-718 Insufficient PCL6 decomposer memory.ProcedurePerform the steps that follow:1. Advise the customer to decrease the resolution to reduce the PLW memory.2. If the fault persists, reload the software, GP 4.**This RAP is from Xerox Service Manual. All brand names and trademarks are their respective owner's property.**You may be also interested in below toner and drum chip (CRUM) for Xerox VersaLink C7020, C7025, C7030, C7000.Toner Chip (For North America and West Europe Region):• 106R03741 106R03744 106R03743 106R03742• 106R03757 106R03760 106R03759 106R03758• 106R03737 106R03740 106R03739 106R03738Toner Chip (For South America and East Europe Region):• 106R03749 106R03752 106R03751...

016-717 Fax Send Result Not Found RAP016-717 The fax or internet fax send result information is not saved in the controller.ProcedureWARNING: Ensure that the electricity to the machine is switched off while performing tasks that do not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause death or injury. Moving parts can cause injury.Perform the steps that follow:1. Advise the customer to:a. Split any internet fax documents that would exceed 2GB in document storage size into several jobs and control the usage amount of memory.b. If there is a large amount of scan or internet fax...