Articles

024-376 IOT-ESS Communication Fail 3 RAPBSD-ON: BSD 3.1 PWB Communications (ESS PWB to Drive PWB)BSD-ON: BSD 6.4 LED Control (Y, M), BSD 6.5 LED Control (C, K).024-376 Drive PWB image signal truncation detected by the controller.ProcedureWARNING: Ensure that the electricity to the machine is switched off while performing tasks that do not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause death or injury. Moving parts can cause injury.Perform the steps that follow:1. Switch off, then switch on the machine, GP 10.2. Ensure that all connectors on the drive PWB, PL 1.10 Item 4 and the...

024-374 RegiCon PLL Parameter Fail RAPBSD-ON: BSD 3.1 PWB Communications (ESS PWB to Drive PWB)024-374 RegiCon adjustment value setting error detected by the controller (incorrect parameter instruction).ProcedureWARNING: Ensure that the electricity to the machine is switched off while performing tasks that do not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause death or injury. Moving parts can cause injury.Perform the steps that follow:1. Switch off, then switch on the machine, GP 10.2. Ensure that all connectors on the drive PWB, PL 1.10 Item 4 and the ESS PWB, PL 3.10 Item 6 are securely connected....

024-371 to 024-373, 024-375 IOT-ESS Communication Fail 2 RAPBSD-ON: BSD 3.1 PWB Communications (ESS PWB to Drive PWB)024-371 Communication between the ESS and IOT has not been established.024-372 Sending error detected by the controller (incorrect parameter instruction).024-373 DLL communication failure recovery error detected by the controller.024-375 DLL receiving error detected by the controller (incorrect parameter instruction).ProcedureWARNING: Ensure that the electricity to the machine is switched off while performing tasks that do not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause death or injury. Moving parts can cause injury.Perform the steps that follow:1. Switch off, then...

024-370 Marker Code Detection Fail RAPBSD-ON: BSD 3.1 PWB Communications (ESS PWB to Drive PWB)024-370 Marker code detection error. During enlarge, when the file was enlarged only by the specified size, the end code (FF02) cannot be found in the compressed data.ProcedureWARNING: Ensure that the electricity to the machine is switched off while performing tasks that do not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause death or injury. Moving parts can cause injury.Perform the steps that follow:1. Switch off, then switch on the machine, GP 10.2. Change the Print mode (Normal/High Quality/High Resolution). Inform...

024-368 PCI Error RAPBSD-ON: BSD 3.9 ESS024-368 PCI access error occurred due to a faulty PCI bus.ProcedureWARNING: Ensure that the electricity to the machine is switched off while performing tasks that do not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause death or injury. Moving parts can cause injury.Perform the steps that follow:1. Switch off, then switch on the machine, GP 10.2. Ensure the connectors on the hard disk are securely connected.3. Format the hard disk drive, refer to dC355 Hard Disk Diagnostics.4. Reload the software, GP 4.5. Perform the OF2 Special Boot Modes RAP.6....