Articles

012-212 Stacker Tray Upper Limit Failure RAPBSD-ON: BSD 13.15 Office Finisher LX Stacker Tray Control012-212 The stacker has continued to elevate after the defined period of time has passed since stacker no paper sensor is on during stacker elevation.Initial ActionsWARNING: Ensure that the electricity to the machine is switched off while performing tasks that do not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause death or injury. Moving parts can cause injury.• Check for obstructions under the tray.• Check the operation of the stack height sensor, PL 13.27 actuators.• Check the tray raise/lower mechanism for...

012-111 to 012-131 Horizontal Transport Entrance Sensor Jam RAPBSD-ON: BSD 13.5 Office Finisher LX Horizontal Transport012-111 The horizontal transport entrance sensor did not deatuate within the specified time.012-112 After the fuser exit sensor was actuated, the horizontal transport entrance sensor did not deatuate within the specified time.012-126 After the horizontal transport entrance sensor was actuated, the horizontal transport entrance sensor did not deactuate within the specified time.012-131 After the fuser exit sensor was actuated, the horizontal transport entrance sensor did not deatuate within the specified time.ProcedureWARNING: Ensure that the electricity to the machine is switched off while performing tasks that...

012-935B Entrance Sensor RAPBSD-ON: BSD 13.7 Office Finisher LX TransportationInitial ActionsNOTE: Ensure the correct RAP is performed, refer to the 012-935 Entrance Sensor Entry RAP.WARNING: Ensure that the electricity to the machine is switched off while performing tasks that do not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause death or injury. Moving parts can cause injury.• Check for obstructions in the paper path• Check that the finisher is docked correctly to ensure proper transport gate operation.Procedure1. Enter dC330 code 012-100. Actuate the transport entrance sensor, PL 13.35 Item 10. The display changes. If YES,...

012-935A Entrance Sensor RAPBSD-ON:BSD 12.3 Integrated Office Finisher TransportationInitial ActionsNOTE: Ensure the correct RAP is performed, refer to the 012-935 Entrance Sensor Entry RAPWARNING: Ensure that the electricity to the machine is switched off while performing tasks that do not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause death or injury. Moving parts can cause injury.• Check the power supply voltage at the customer site for a drop.• Check the finisher entrance sensor, PL 12.12 Item 19 is correctly installed and free from foreign objects and that the actuator is not binding.• Switch off, then...

012-935 Entrance Sensor Entry RAP012-935 The finisher entry sensor was detected on.ProcedureGo to the relevant procedure:• Integrated office finisher installed, 012-935A Entrance Sensor RAP.• Office finisher LX installed, 012-935B Entrance Sensor RAP.**This RAP is from Xerox Service Manual. All brand names and trademarks are their respective owner's property.**You may be also interested in below toner and drum chip (CRUM) for Xerox VersaLink C7020, C7025, C7030, C7000.Toner Chip (For North America and West Europe Region):• 106R03741 106R03744 106R03743 106R03742• 106R03757 106R03760 106R03759 106R03758• 106R03737 106R03740 106R03739 106R03738Toner Chip (For South America and East Europe Region):• 106R03749 106R03752 106R03751 106R03750• 106R03745 106R03748...