Articles

024-361 Invalid IOT Paper Size RAPBSD-ON: BSD 3.1 PWB Communications (ESS PWB to Drive PWB)024-361 Invalid IOT paper size group information.ProcedureWARNING: Ensure that the electricity to the machine is switched off while performing tasks that do not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause death or injury. Moving parts can cause injury.Perform the steps that follow:1. Switch off, then switch on the machine, GP 10.2. Ensure that all connectors on the drive PWB, PL 1.10 Item 4 and the ESS PWB, PL 3.10 Item 6 are securely connected. Ensure all surface mounted modules on...

024-340 to 024-360 IOT-ESS Communication Fail 1 RAPBSD-ON: BSD 3.1 PWB Communications (ESS PWB to Drive PWB)024-340 Drive PWB sending error detected by controller (invalid parameter was used).024-341 Drive PWB sending error detected by controller (sequence number error).024-342 Drive PWB sending error detected by controller (packet number error).024-343 Drive PWB sending error detected by controller (message length error).024-345 Drive PWB sending error detected by controller (check code error).024-346 Drive PWB sending error detected by controller (parity error detected by the IOT.024-347 Drive PWB sending error detected by controller (framing error detected by the IOT).024-348 Drive PWB sending error detected by...

023-600, 023-601 UI Key Error RAP023-600 A hard key on the panel has been found to be held down for one or more consecutive minutes.023-601 The touch panel has been found to be held down for one or more consecutive minutes.ProcedureFor information only, no service action necessary.**This RAP is from Xerox Service Manual. All brand names and trademarks are their respective owner's property.**You may be also interested in below toner and drum chip (CRUM) for Xerox VersaLink C7020, C7025, C7030, C7000.Toner Chip (For North America and West Europe Region):• 106R03741 106R03744 106R03743 106R03742• 106R03757 106R03760 106R03759 106R03758• 106R03737 106R03740 106R03739...

023-500 UI ROM Download Fail RAP023-500 Panel ROM data write processing error detection.ProcedureWARNING: Ensure that the electricity to the machine is switched off while performing tasks that do not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause death or injury. Moving parts can cause injury.Perform the steps that follow:1. Reload the software, GP 4.2. If the fault persists, install a new UI assembly, PL 2.05 Item 7.**This RAP is from Xerox Service Manual. All brand names and trademarks are their respective owner's property.**You may be also interested in below toner and drum chip (CRUM) for...

021-947, 948, 949 Subtractive Accessory Disable (Scan) RAP021-947 The remaining rate subtractive accessory is insufficient (scan service paused by subtractive accessory disable).021-948 The remaining rate subtractive accessory has is insufficient (print service paused by subtractive accessory disable).021-949 The remaining rate subtractive accessory has is insufficient (service paused by subtractive accessory disable).ProcedureAdvise the customer that in the case of dispenser, to insert a card that has a remaining rate enough to continue the job. In the case of coin kit, to add a necessary amount of money to continue the job.**This RAP is from Xerox Service Manual. All brand names and...