Articles

071-210 Tray 1 Lift Fail RAPBSD-ON: BSD 7.7 Tray 1 Paper Stacking071-210 Tray 1 lift NG has occurred three consecutive times.Initial Actions• Check for obstructions behind the tray.• Ensure that the tray is loaded correctly.• Ensure the tray is pushed fully home.• Check the drive system between the bottom plate and the tray 1 feed/lift motor for operation failure.ProcedureWARNING: Ensure that the electricity to the machine is switched off while performing tasks that do not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause death or injury. Moving parts can cause injury.Refer to the procedures that...

024-950 Tray 1 Empty RAPBSD-ON: BSD 7.7 Tray 1 Paper Stacking024-950 Tray 1 is empty.Initial ActionsWARNING: Ensure that the electricity to the machine is switched off while performing tasks that do not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause death or injury. Moving parts can cause injury.Switch off, then switch on the machine, GP 10.Procedure1. Enter dC330, code 071-101, tray 1 no paper sensor. Manually actuate the tray 1 no paper sensor, PL 80.10 Item 6. The display changes. If YES, go to 3. If NO, go to 2.2. Check the tray 1 no...

024-943, 978, 984, 989 Booklet Staple RAP024-943 Both front and rear booklet staples are running low, or a staple cartridge was removed.024-978 Ready signal remains not ready when the specified time has passed since booklet staple operation has begun.024-984 Booklet low front staple.024-989 Booklet low rear staple.ProcedurePerform the 012-268 Booklet Rear Stapler Fail RAP.**This RAP is from Xerox Service Manual. All brand names and trademarks are their respective owner's property.**You may be also interested in below toner and drum chip (CRUM) for Xerox VersaLink C7020, C7025, C7030, C7000.Toner Chip (For North America and West Europe Region):• 106R03741 106R03744 106R03743 106R03742•...

024-942, 024-975 Booklet Sheet Count RAP024-942 Booklet sheets over count. The number of sheets in a booklet is over the limit.024-975 Number of Booklet sheets exceeded (occurs at process with no images).ProcedureWARNING: Ensure that the electricity to the machine is switched off while performing tasks that do not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause death or injury. Moving parts can cause injury.Perform the steps that follow:1. Ensure that the job is programmed in compliance with the maximum number of sheets for a booklet.2. Ensure that all connectors on the drive PWB, PL 1.10...

024-939 OHP Type Mismatch RAP024-939 Paper type mismatch. the system is shut down (stop) if transparencies with borders are detected regardless of the paper type setting in the controller.ProcedureWARNING: Ensure that the electricity to the machine is switched off while performing tasks that do not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause death or injury. Moving parts can cause injury.Perform the steps that follow:1. Check the UI settings, ensure that bypass tray is selected and the correct media used.2. Ensure that all connectors on the drive PWB, PL 1.10 Item 4 and the ESS...