Articles

124-327 IOT Speed Change Fail RAP124-327 A SW error was detected during the procedure for changing IOT speed.ProcedureWARNING: Ensure that the electricity to the machine is switched off while performing tasks that do not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause death or injury. Moving parts can cause injury.Perform the steps that follow:1. Switch off, then switch on the machine, GP 10.2. Ensure that all connectors on the ESS PWB, PL 3.10 Item 6 are securely connected. Ensure all surface mounted modules are securely connected.3. Reload the software, GP 4.4. If the fault persists,...

124-326 IOT Speed Not Registered RAP124-326 IOT Speed not registered.ProcedureAdvise the customer to follow the instructions on the UI in order to enter the SW key for changing IOT speed.**This RAP is from Xerox Service Manual. All brand names and trademarks are their respective owner's property.**You may be also interested in below toner and drum chip (CRUM) for Xerox VersaLink C7020, C7025, C7030, C7000.Toner Chip (For North America and West Europe Region):• 106R03741 106R03744 106R03743 106R03742• 106R03757 106R03760 106R03759 106R03758• 106R03737 106R03740 106R03739 106R03738Toner Chip (For South America and East Europe Region):• 106R03749 106R03752 106R03751 106R03750• 106R03745 106R03748 106R03747 106R03746•...

124-325 Billing Restoration Fail RAP124-325 Billing counter mismatch (1 position).ProcedureWARNING: Ensure that the electricity to the machine is switched off while performing tasks that do not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause death or injury. Moving parts can cause injury.1. Switch off, then switch on the machine, GP 10. The fault persists. If YES, go to 3. If NO, go to 2.2. Perform SCP 5 Final Actions.3. Enter dC132 Device ID and Billing Data. The 3 values match. If YES, go to 5. If NO, go to 4.4. Perform dC132. Make all three...

124-323 DC132 06 RAP124-323 Internal control error was detected.ProcedureWARNING: Ensure that the electricity to the machine is switched off while performing tasks that do not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause death or injury. Moving parts can cause injury.1. Switch off, then switch on the machine, GP 10. The fault persists. If YES, go to 3. If NO, go to 2.2. Perform SCP 5 Final Actions.3. Enter dC131. Compare NVM values 700-603, 700-604 and 700-605. The 3 values match. If YES, go to 5. If NO, go to 4.4. Perform dC132. Make all...

124-321 Backup SRAM Fail RAP124-321 Write error occurred in the NVM on the ESS PWB.ProcedureWARNING: Ensure that the electricity to the machine is switched off while performing tasks that do not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause death or injury. Moving parts can cause injury.Perform the steps that follow:1. Switch off, then switch on the machine, GP 10.2. Ensure that all connectors on the ESS PWB, PL 3.10 Item 6 are securely connected. Ensure all surface mounted modules are securely connected.3. Ensure that the fax PWBs, PL 20.05 are installed correctly.NOTE: Line 2...