Articles

016-359, 016-361 Controller USB Fail RAP016-359 Cont USB HUB diagnostic fail.016-361 Cont USB 3.0 device diagnostic fail.ProcedureWARNING: Ensure that the electricity to the machine is switched off while performing tasks that do not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause death or injury. Moving parts can cause injury.Perform the steps that follow:1. Install a new ESS PWB, PL 3.10 Item 6.**This RAP is from Xerox Service Manual. All brand names and trademarks are their respective owner's property.**You may be also interested in below toner and drum chip (CRUM) for Xerox VersaLink C7020, C7025, C7030,...

016-358 Controller Parallel Card Fail RAP016-358 Controller parallel port diagnostic fail.ProcedureWARNING: Ensure that the electricity to the machine is switched off while performing tasks that do not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause death or injury. Moving parts can cause injury.Perform the steps that follow:1. Switch off, then switch on the machine, GP 10.2. Reload the software, GP 4.3. If the fault persists, install a new ESS PWB, PL 3.10 Item 6.**This RAP is from Xerox Service Manual. All brand names and trademarks are their respective owner's property.**You may be also interested in...

016-357 Controller EP Communication Fail RAP016-357 Controller to EP-controller communication fail.ProcedureWARNING: Ensure that the electricity to the machine is switched off while performing tasks that do not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause death or injury. Moving parts can cause injury.Perform the steps that follow:1. Switch off, then switch on the machine, GP 10.2. Ensure that all connectors on the ESS PWB, PL 3.10 Item 6 are securely connected. Ensure all surface mounted modules are securely connected.3. Reload the software, GP 4.4. Perform the OF2 Special Boot Modes RAP.5. If the fault persists,...

016-355, 016-356 Controller ASIC Fail RAP016-355 Cont IO ASIC diagnostic fail.016-356 Cont video ASIC diagnostic fail.ProcedureWARNING: Ensure that the electricity to the machine is switched off while performing tasks that do not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause death or injury. Moving parts can cause injury.Perform the steps that follow:1. Switch off, then switch on the machine, GP 10.2. Ensure that all connectors on the ESS PWB, PL 3.10 Item 6 are securely connected. Ensure all surface mounted modules are securely connected.3. Reload the software, GP 4.4. If the fault persists, install a...

016-353, 016-354 IOT-Controller Communication Fail RAP016-353 Communication cannot be established between the IOT and the ESS.016-354 Communication cannot be established between the IIT and the controller.ProcedureWARNING: Ensure that the electricity to the machine is switched off while performing tasks that do not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause death or injury. Moving parts can cause injury.Perform the steps that follow:1. Switch off, then switch on the machine, GP 10.2. Ensure that all connectors on the drive PWB, PL 1.10 Item 4 and the ESS PWB, PL 3.10 Item 6 are securely connected. Ensure...