Articles

089-600 RC Sample Lateral Fail-A1 RAP089-600 An error with the Cyan fast scan position that is used as a reference during A1 (fine adjustment pattern) and C patch detection.Initial ActionsEnter dC125, if multiple chain 89 faults are indicated, refer to Chain 089 Entry RAP to determine the highest priority fault.ProcedureWARNING: Ensure that the electricity to the machine is switched off while performing tasks that do not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause death or injury. Moving parts can cause injury.1. Check the installation and condition of the IBT Belt Unit, PL 90.45 Item...

Chain 089 Entry RAPWhen multiple Chain 89 fault codes are indicated in the active fault list (dC125) fixing higher priority faults can result in automatically fixing other, lower priority faults. Fix faults in the order indicated in Table 1.Chain 89 Fault Priority Table 1 Chain 89 RAP Priority Priority Fault Code Fault 1(High) 089-616 RC Data Overflow Fail-B 2 089-604, 089-606, 089-607, 089-609, 089-610, 089-612, 089-613, 089-615 RC Sample Block Fail-B 3 089-601, 089-603 Sample Block Fail-A1 4 089-600 RC Sample Lateral Fail-A1 5 089-617 RC Data Over Range 6(Low) 089-623, 089-629, 089-674, 089-676, 089-677, 089-679 MOB LED Fail **This...

078-301 HCF Docking interlock Open RAPBSD-ON: BSD 1.11 DC Power Distribution - HCF078-301 HCF1 side out switch open. The HCF and the IOT were undocked.Initial ActionsWARNING: Ensure that the electricity to the machine is switched off while performing tasks that do not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause death or injury. Moving parts can cause injury.• Check that the HCF and the IOT are correctly docked.• Switch off, then switch on the machine, GP 10.ProcedureRefer to the procedure that follows as necessary:• GP 9 How to Check a Switch.1. Enter dC330 code 078-301....

078-300 HCF Top Cover Interlock Open RAPBSD-ON: BSD 1.11 DC Power Distribution - HCF078-300 The HCF top cover interlock is open.ProcedureWARNING: Ensure that the electricity to the machine is switched off while performing tasks that do not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause death or injury. Moving parts can cause injury.Refer to the procedure that follows as necessary:• GP 9 How to Check a Switch.1. Enter dC330 code 078-300. Open then close the top cover, PL 70.55 Item 7 to actuate the HCF top cover interlock switch. The display changes. If YES, go...

078-216, 078-219 HCF Communication Failure RAP078-216 Cannot read from and/or write to the NVM in the HCF.078-219 HCF soft download fail.ProcedureWARNING: Ensure that the electricity to the machine is switched off while performing tasks that do not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause death or injury. Moving parts can cause injury.Perform the steps that follow:1. Switch off, then switch on the machine, GP 10.2. Check wires and connectors between the HCF and the IOT.3. Reload the software, GP 4.4. If the fault persists, install a new HCF PWB, PL 70.60 Item 9.**This RAP...