Articles

012-260, 012-282 Eject Clamp Home Sensor Fail RAPBSD-ON: BSD 13.13 Office Finisher LX Eject Control (1 of 2)012-260 After the eject clamp started ascending, the eject clamp home sensor did not turn on within 500ms.012-282 After the eject clamp started descending, the eject clamp home sensor did not turn off within 200ms.Initial ActionsWARNING: Ensure that the electricity to the machine is switched off while performing tasks that do not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause death or injury. Moving parts can cause injury.• Manually operate the eject mechanism. Check for binding, a dirty...

012-249 Booklet Front Stapler Fail RAPBSD-ON: BSD 13.4 Office Finisher LX Booklet Interlock SwitchingBSD-ON: BSD 13.17 Office Finisher LX Booklet Staple Control (1 of 2 - Front)012-249 The booklet front staple home switch is not on (does not return to home position) within the specified time after the booklet front staple motor starts to reverse.Initial ActionsWARNING: Ensure that the electricity to the machine is switched off while performing tasks that do not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause death or injury. Moving parts can cause injury.Check the booklet front stapler for jammed staples...

012-243, 012-265 Booklet Folder Home Sensor Fail RAPBSD-ON: BSD 13.8 Office Finisher LX Folding012-243 Folder home sensor is not actuated after the lapse of 500ms from motor on while folder knife is returning to home.012-265 When the booklet home moves from home position, the folder home sensor did not turn off within the specified time.Initial ActionsWARNING: Ensure that the electricity to the machine is switched off while performing tasks that do not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause death or injury. Moving parts can cause injury.• Check the folder home sensor, PL 13.40...

012-231 Punch Home Sensor Fail RAPBSD-ON: BSD 13.6 Office Finisher LX Punch012-231 The punch home sensor did not turn on within the specified time after the punch motor started running.Initial ActionsWARNING: Ensure that the electricity to the machine is switched off while performing tasks that do not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause death or injury. Moving parts can cause injury.• Check the punch home actuator for deformation.• Check the punch home sensor, PL 13.09 Item 5 for proper installation.Procedure1. Enter dC330 code 12-074 and 12-078 alternately to run the punch motor. The...

012-213 Stacker Tray Lower Limit Failure RAPBSD-ON: BSD 13.15 Office Finisher LX Stacker Tray Control012-213 Stacker descended lower than normal levels, below low limit height.Initial Actions• Check for obstructions under the tray.• Check the operation of the stack height sensor, PL 13.27 actuators.• Check the tray raise/lower mechanism for damage or contamination.Procedure1. Enter dC330 code 012-264. Actuate the stack height sensor 1. The display changes. If YES, go to 9. If NO, go to 2.2. Check the wiring between J8873 pin 2 and P/J8988 pin 17 for an open or short circuit, or a loose or damaged connector. The wiring...