Articles

078-104, 078-901 HCF Feed Out Sensor Fault RAPBSD-ON: BSD 8.8 HCF Paper Transportation078-104 Paper fed from the HCF did not actuate the HCF feed out sensor within the specified time.078-901 The HCF feed out sensor detected paper.Initial ActionsWARNING: Ensure that the electricity to the machine is switched off while performing tasks that do not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause death or injury. Moving parts can cause injury.• Check the condition of the paper in the HCF. Refer to GP 15 Paper and Media Size Specifications.• Check for obstructions in the paper path.ProcedureRefer...

078-102 Registration Sensor Jam (HCF) RAPBSD-ON: BSD 8.5 RegistrationBSD-ON: BSD 8.8 HCF Paper Transportation078-102 Paper fed from the HCF did not actuate the registration sensor within the specified time.Initial ActionsWARNING: Ensure that the electricity to the machine is switched off while performing tasks that do not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause death or injury. Moving parts can cause injury.• Check the condition of the paper in the HCF. Refer to GP 15 Paper and Media Size Specifications.• Check for obstructions in the paper path.ProcedureRefer to the procedures that follow as necessary:• GP...

077-967, 968 Paper Mismatch RAP077-967 The paper loaded is different from the specified paper type.077-968 The paper loaded is different from the specified paper type.Procedure1. Switch off, then switch on the machine, GP 10. The fault persists. If YES, go to 3. If NO, go to 2.2. Perform SCP 5 Final Actions.3. Load the specified paper, then resubmit the job.**This RAP is from Xerox Service Manual. All brand names and trademarks are their respective owner's property.**You may be also interested in below toner and drum chip (CRUM) for Xerox VersaLink C7020, C7025, C7030, C7000.Toner Chip (For North America and West...

077-308 L/H High Cover Open RAPBSD-ON: BSD 10.5 Fused Paper Exit 2077-308 L/H high cover was opened during run.ProcedureWARNING: Ensure that the electricity to the machine is switched off while performing tasks that do not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause death or injury. Moving parts can cause injury.Refer to the procedure that follows as necessary:• GP 9 How to Check a SwitchPerform the steps that follow:1. Check the actuator on the left hand transport assembly, PL 10.20 Item 2 for damage. If necessary, install a new left hand transport assembly.2. Enter dC330...

077-305 TM Left Cover Open RAPBSD-ON: BSD 1.9 Power Interlock Switching (2 of 3)077-301 Tray module left cover was opened during run.ProcedureWARNING: Ensure that the electricity to the machine is switched off while performing tasks that do not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause death or injury. Moving parts can cause injury.Refer to the procedure that follows as necessary:• GP 9 How to Check a SwitchPerform the steps that follow:1. Check the actuator on the tray module left cover for damage. If necessary, install a new tray module left cover:• (1TM), PL 70.16...