Articles

077-301 L/H Cover Open RAPBSD-ON: BSD 1.8 Power Interlock Switching (1 of 3)077-301 L/H cover was opened during run.ProcedureWARNING: Ensure that the electricity to the machine is switched off while performing tasks that do not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause death or injury. Moving parts can cause injury.Refer to the procedure that follows as necessary:• GP 9 How to Check a SwitchPerform the steps that follow:1. Check the actuator on the L/H cover for damage. If necessary, install a new L/H cover, PL 80.40 Item 8.2. Enter dC330 code 077-300. Check the...

PurposeUse this procedure to check the operation of a switch.NOTE: The circuit in Figure 1 shows an interlock switch actuated by the closing of a door.Initial ActionsWARNING: Ensure that the electricity to the machine is switched off while performing tasks that do not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause death or injury. Moving parts can cause injury.Manually check that the switch operates. Ensure that the magnet or other actuator has enough mechanical movement to operate the switch.NOTE: The voltages, PJ numbers, pin numbers and PWB names shown are an example only.Procedure• Disconnect PJA...

077-300 Front Cover Open RAPBSD-ON: BSD 1.8 Power Interlock Switching (1 of 3)077-300 Front cover was opened during run.ProcedureWARNING: Ensure that the electricity to the machine is switched off while performing tasks that do not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause death or injury. Moving parts can cause injury.Refer to the procedure that follows as necessary:• GP 9 How to Check a SwitchPerform the steps that follow:1. Check the actuator on the front cover for damage. If necessary, install a new front cover, PL 28.05 Item 2.2. Enter dC330 code 077-303. Check the...

077-212, 214, 215, 314 Tray Module Communication Fail RAPBSD-ON: BSD 1.7 Option DC Power DistributionBSD-ON: BSD 3.2 PWB Communications (ESS PWB/Drive PWB to STM)BSD-ON: BSD 3.3 PWB Communications (ESS PWB/Drive PWB to 1TM/3TM/TTM)077-212 Tray module reset was detected.077-214 Tray module fatal error was detected.077-215 Reply from the tray module was detected as a communication error.077-314 Tray module fatal error was detected.ProcedureWARNING: Ensure that the electricity to the machine is switched off while performing tasks that do not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause death or injury. Moving parts can cause injury.Perform the steps...

077-211 Tray Module Mismatch RAPBSD-ON: BSD 3.2 PWB Communications (ESS PWB/Drive PWB to STM)BSD-ON: BSD 3.3 PWB Communications (ESS PWB/Drive PWB to 1TM/3TM)077-211 A tray module mismatch has occurred.ProcedureWARNING: Ensure that the electricity to the machine is switched off while performing tasks that do not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause death or injury. Moving parts can cause injury.Perform the steps that follow:1. Switch off, then switch on the machine, GP 10.2. Check the connections between the tray module and the machine.3. Enter dC131. Ensure that the tray module type is correctly set...