Articles

112-700 Punch Bin Almost Full RAP112-700 The punch debris bin is almost full.ProcedureAdvise the customer to empty the punch debris bin.**This RAP is from Xerox Service Manual. All brand names and trademarks are their respective owner's property.**You may be also interested in below toner and drum chip (CRUM) for Xerox VersaLink C7020, C7025, C7030, C7000.Toner Chip (For North America and West Europe Region):• 106R03741 106R03744 106R03743 106R03742• 106R03757 106R03760 106R03759 106R03758• 106R03737 106R03740 106R03739 106R03738Toner Chip (For South America and East Europe Region):• 106R03749 106R03752 106R03751 106R03750• 106R03745 106R03748 106R03747 106R03746• 106R03765 106R03768 106R03767 106R03766Toner Chip (For Metered Machine):• 106R03733...

103-314 Prohibited Originals RAP103-314 Possible prohibited originals (system fail).ProcedureWARNING: Ensure that the electricity to the machine is switched off while performing tasks that do not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause death or injury. Moving parts can cause injury.Perform the steps that follow:1. Switch off, then switch on the machine, GP 10.2. Ensure that all connectors on the drive PWB, PL 1.10 Item 3 and the ESS PWB, PL 3.10 Item 6 are securely connected. Ensure all surface mounted modules on both PWBs are securely connected.3. Initialise the hard disk, refer to dC355...

103-310 to 103-313 Hybrid Water Mark RAP103-310 The secure watermark kit cannot be made available because the hybrid watermark detection hardware is not installed.103-311 The secure watermark Kit is not enabled.103-312 The secure watermark kit cannot be made available because the hybrid watermark detection hardware for document side 2 is not installed.103-313 The secure watermark kit did not become available because of insufficient IISS extension memory.ProcedureFor information only. No service action necessary.**This RAP is from Xerox Service Manual. All brand names and trademarks are their respective owner's property.**You may be also interested in below toner and drum chip (CRUM) for...

102-356 EWS Soft Fail RAP102-356 Fatal error related to EWS.ProcedureWARNING: Ensure that the electricity to the machine is switched off while performing tasks that do not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause death or injury. Moving parts can cause injury.Perform the steps that follow:1. Switch off, then switch on the machine, GP 10.2. Ensure that all connectors on the drive PWB, PL 1.10 Item 3 and the ESS PWB, PL 3.10 Item 6 are securely connected. Ensure all surface mounted modules on both PWBs are securely connected.3. Initialise the hard disk, refer to...

102-311 to 102-319 USB Dongle Errors RAP102-311 USB dongle access failed during the initial installation by the USB dongle.102-312 It was detected that MAC address of another M/C was recorded in the dongle during the initial installation by the USB dongle.102-313 An illegal IOT speed setting key was detected during the initial installation by the USB dongle.102-314 Setting the IOT speed setting key failed during the initial installation by the USB dongle.102-315 Setting the SW Key failed during the initial installation by the USB dongle.102-316 Setting the supply setting failed during the initial installation by the USB dongle.102-317 Setting the...