Articles

003-946 Image Rotation (Copy APS) RAP003-946 Part of the image will be lost if the image is not rotated. However, a paper size that does not support rotation was selected.ProcedurePerform the steps that follow:1. Advise the customer to manually select an appropriate paper tray, then retry the job.2. If the fault persists, reload the software, GP 4.**This RAP is from Xerox Service Manual. All brand names and trademarks are their respective owner's property.**You may be also interested in below toner and drum chip (CRUM) for Xerox VersaLink C7020, C7025, C7030, C7000.Toner Chip (For North America and West Europe Region):• 106R03741...

003-944 Repeat Image Count Fail RAP003-944 Incorrect image repeat count (even one image cannot be pasted).ProcedurePerform the steps that follow:1. Advise the customer to change the image repeat count parameter, then retry the job.2. If the fault persists, reload the software, GP 4.**This RAP is from Xerox Service Manual. All brand names and trademarks are their respective owner's property.**You may be also interested in below toner and drum chip (CRUM) for Xerox VersaLink C7020, C7025, C7030, C7000.Toner Chip (For North America and West Europe Region):• 106R03741 106R03744 106R03743 106R03742• 106R03757 106R03760 106R03759 106R03758• 106R03737 106R03740 106R03739 106R03738Toner Chip (For South...

005-196, 198, 199, 946, 948, 949, 950 Size Mismatch Jam RAPBSD-ON: BSD 5.5 Document Feeding (2 of 2)005-196 The 2nd sheet or later of the set was detected to be of a different size to the 1st sheet.005-198 The length of the vertical scanning direction is less than the specified value, simplex 85mm (3.3 inches), duplex 110mm (4.3 inches).005-199 The length of vertical scanning direction is the specified value or more, simplex 1275mm (50.1 inches), duplex 480.1mm (18.9 inches).005-946 In no mix mode, a document with a shorter size in slow scan (SS) direction was fed.005-948 In no mix mode,...

PurposeUse this procedure to check the operation of a sensor.NOTE: The upper circuit diagram in Figure 1 shows a flag sensor. Some sensors have a resistor within the sensor. Other sensors require a resistor on the PWB, such as R1 in Figure 1. The resistor limits the current through the LED. This decreases the voltage on the sensor LED to 1.2V, typically.NOTE: The voltages, PJ numbers, pin numbers and PWB names shown are an example only.Initial ActionsWARNING: Ensure that the electricity to the machine is switched off while performing tasks that do not need electricity. Refer to GP 10. Disconnect...

005-194 Size Mismatch Jam on SS Mix-Size RAPBSD-ON: BSD 5.3 DADF Document Size Sensing (2 of 2)005-194 When 'Slow Scan MIX' is specified, it was detected that the size in the fast scan direction was different from that of the document guide width.ProcedureWARNING: Ensure that the electricity to the machine is switched off while performing tasks that do not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause death or injury. Moving parts can cause injury.Refer to the procedure that follows as necessary:• GP 7 How to Check a Sensor.Perform the steps that follow:1. Check the...